IPsec, L2TP, Split tunneling, PPTP and all other VPN related posts.
Hello !I have a question, please answer as soon as possbile. Look Im new in routing, just lerning CCNA Discovery course, there is the problem: okay, Im setting up a ROUTER, and 2 Switches, I configure it through terminal:the final result we have:eth 0/0 from where internet is coming - IP - 192.168.100.200eth 0/1 (inside network) - IP - 192.168.80.1 Also I configured ARP in the same way: slash (config)# router rip slash (config-router)# network 192.168.100.0 // AS I understand ARP allows to transffer data beetween the networks and make it visible on to other slash (config-router)# network 192.168.80.0 now if I ping the both network end devices (PC) the ping works and the packet a sent and recieved.!!!! THE PROBLEM IS> Why I cannot ping from (PC0) 192.168.100.201 the 192.168.80.2 (PC1)the RIP was made. In the attach there is my Paket tracert scheme. Thx for the answer and attention!
In your diagram, you only have one router and both subnet is directly connected to this router. Therefore, you don need any routing configuration here. Routing protocol such as RIP is used to tell the other router in your network about routing information.For example, in the following topology, you need run routing protocol on all three routers so that Router1 could learn the route to 22.214.171.124/24 and 126.96.36.199/24 which are not directly connected to it. (188.8.131.52/24)--Router1--(184.108.40.206/24)----Router2----(220.127.116.11/24)-----Router3----(18.104.22.168/24)
1 )okay, I see.. so there is the next situation: eth 0/1 > 192.168.100.200eth 0/2> 10.10.0.1 The network (192.168.100.0 has the access to internet through the gateway - 192.168.100.100 (the server) and its DNS are: 22.214.171.124; 126.96.36.199 ) So, on the router I add this interfaces:eth 0/1 > 192.168.100.200 eth 0/2> 10.10.0.1 what after that? how to add the dns servers? and I have to show this ip 192.168.100.100 somewhare? so please write how it should look like, in real conditions Im usnig CISCO 2800 series router.