• Advertisement

6500 - IOS Upgrade

This is for more general topics about networking and vendors.

6500 - IOS Upgrade

Postby Guest » Sun Jan 09, 2011 2:10 pm

Hi,

 

6506 is running CAT OS and I need to upgrade the software to IOS. On CAT OS the switching module and routing module are on different session.

 

My question

1 After upgrade wil I get single session to manage switching & routing module

(2) on CATOS we got LACP configured ; is any modification needed on it

(3) Any Change in configuration is needed for Two SUP

 

Anything else to watch out before the upgrade.

 

Thanks

ST

Guest
 

Advertisement

Re:6500 - IOS Upgrade

Postby Guest » Sun Jan 09, 2011 2:23 pm

Hello Saquib,

 

you need to follow the procedure for CatOS to IOS conversion

 

you need to do it two times one for each supervisor /MSFC

 

so your first step is to remove one sup convert  the remaining sup, then you will remove the converted supervisor and you will insert the other one alone and you will perform conversion again for the second supervisor.

At the end you will insert first sup again and you should be able to get one active and the other standby in native mode

 

at the end you will get a single session to access the device

 

(2) on  CATOS we got LACP configured ; is any modification needed on it

 

LACP is supported on IOS too but you need to configure it. By the way the device needs to be configured.

There is a config conversion tool but it is not recommended.

 

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml

 

follow the document step by step depending on your sup model

 

HW and SW requirements are listed

 

it will take some time (hours)

 

Hope to help

Giuseppe

Guest
 

Re:6500 - IOS Upgrade

Postby Guest » Sun Jan 09, 2011 3:58 pm

Giuseppe Thanks

 

You are alwayz a great help :-)

 

I will follow as you recommended.

 

Ganesh thanks as well.

Guest
 

Re:6500 - IOS Upgrade

Postby Guest » Sun Jan 09, 2011 4:49 pm

Guest
 



  • Advertisement


Similar topics

upgrade my CME
Forum: Cisco IP Communications
Author: Guest
Replies: 0

Basic questions on 4500 upgrade
Forum: Cisco Switching
Author: Anonymous
Replies: 0

Upgrade Question
Forum: Cisco IP Communications
Author: Anonymous
Replies: 0

Questions regarding upgrade CUCM4.2 to CUCM 7.1.3 using DMA
Forum: Cisco IP Communications
Author: Anonymous
Replies: 2

6500 VSS connectivity
Forum: Cisco Switching
Author: Anonymous
Replies: 0


Return to Anything Networking

Who is online

Users browsing this forum: No registered users and 3 guests