• Advertisement

Why labels in MPLS?

Static, RIP, EIGRP, OSPF, BGP, IBGP, IS-IS and any other routing.

Why labels in MPLS?

Postby Guest » Wed Mar 17, 2010 9:26 pm

Am very new to MPLS concepts. So kindly help me to get my doubt clarified.

In routers, we have table to maintain the ip, in-label, out-going interface and out-label.

Instead of using the labels, just cant we use the out-going interface exit interface to direct the packets to reach the destination?

kindly help me out.....

Guest
 

Advertisement

Re:Why labels in MPLS?

Postby Guest » Wed Mar 17, 2010 10:16 pm

Hello Robert,

 

the objective is to be able to foward MPLS frame without examining the payload (that can be IPv4 or other stuff) the label is needed to make possible for transit routers to swap labels: the information of outgoing interface is useful but it is not enough.

 

Different LSPs can have part of their path in common but at some place in the network they can take different paths to reach different Edge LSR / PE nodes.

For this reason each end to end path (unidirectional) needs its own set of labels to be used at each router hop in the path.

 

This is similar to what happens in WAN technologies like frame relay or ATM where a logical circuit identifier is used at each switch hop.

 

With FR an end to end path uses for example DLCI 50 then DLCI 88,  ... and reach the other device with DLCI 201 for example.

 

the label values can be reused in different places of the network exactly as it happens for FR DLCI values.

 

The labels have local meaning as it happens for FR DLCI values.

 

Hope to help

Giuseppe

Guest
 

Re:Why labels in MPLS?

Postby Guest » Wed Mar 17, 2010 11:13 pm

Hi Giuslar,

     Thank you so much for you clarification about my question. kindly help me in due course of time as am new to MPLS.

Guest
 



  • Advertisement


Similar topics

MPLS Bandwidth provisioning
Forum: Anything Networking
Author: Anonymous
Replies: 2

Basic MPLS VPN
Forum: Cisco Switching
Author: Anonymous
Replies: 0

I want EIGRP to pick the MPLS not the DMVPN but it doesn
Forum: Cisco Switching
Author: Anonymous
Replies: 0

MPLS Customer router physical interface
Forum: Routing Protocols
Author: Anonymous
Replies: 0

VPLS over Carrier Supporting Carrier MPLS VPN
Forum: Routing Protocols
Author: Anonymous
Replies: 0


Return to Routing Protocols

Who is online

Users browsing this forum: No registered users and 1 guest

cron